Tilt Drawer Box for Multiboard – Push-Push Screw Storage

This compact tilt drawer gives you a clean, handle-free way to store screws, nuts, and small workshop accessories directly on your Multiboard panel. Press the front once to open, press again to close — no handles, no clutter, no digging around for the right fastener.

How it works

The push-push mechanism means the front face stays completely smooth when closed. A single press releases the drawer, which automatically tilts forward so the contents are immediately visible and easy to grab. Another press snaps it shut. It runs on a small rubber band (1.4 × 16 mm or 1.4 × 20 mm) that drives the tilt action — this is included or easy to source, but the specific size matters for reliable operation.

What you get

You receive the fully assembled drawer unit, ready to mount. There is nothing to build or assemble beyond attaching it to your workspace.

• Push-push front — no handle, no protruding parts
• Auto-tilt drawer for instant visibility and one-handed access
• Internal storage cavity: 32 × 42 × 32 mm — fits M3/M4/M5 screws, bits, pins, and similar small parts
• Overall unit size: 49.6 × 49.6 × 48.2 mm
• Compatible with standard Multiboard panels
• Also mounts with two Ø3.5 mm screws or double-sided tape

Where it fits

If you run a Multiboard setup in your workshop, garage, or maker space, this drawer slots straight in. It works equally well screwed to a wall panel or stuck behind a workbench with tape. Because the front is flat when closed, you can run multiple units side by side without the visual noise of handles and knobs.

Each unit is made to order, inspected, and shipped directly to your door. You unbox it, mount it, and it works.