Dewalt DW715 Miter Saw Cable Holder Replacement

That frayed, dangling power cord on your DW715 isn't just an eyesore — it's a tripping hazard and a slow path to a damaged cable. The original cord holder on a Dewalt miter saw takes a beating over time, and once it breaks, most people just tape the cord down and forget about it. This is the proper fix.

The fix

This replacement cord holder is built specifically for the back of the Dewalt DW715 miter saw. It slots into the same position as the original, keeping your power cord routed cleanly and securely out of the way when the saw is in use or being moved around the shop. No improvised zip ties. No tape. Just the cord where it belongs.

• Direct replacement for the factory cord holder on the Dewalt DW715
• Keeps your power cable routed and protected along the back of the saw
• Prevents cord stress and wear caused by pulling at awkward angles
• Snaps into the original mounting position — no drilling, no modifications
• Solid and rigid — holds the cord in place under normal workshop use

Built for the workshop

This isn't a generic cable clip — it's a part made to match the original geometry of your saw. If you've already lost or broken the factory holder, you know how annoying it is to track down a replacement through official service channels. This gets you sorted without the wait, the inflated part pricing, or the hassle of calling a service center.

It arrives ready to install. No assembly, no setup — just clip it on and route your cord through it the same way you always did. Your DW715 gets back to working the way it should.

When you'll use it

Whether you're restoring an older DW715 back to full working order, or you've just snapped the original holder during a job, this fits the bill. A small part that makes a real difference in how your saw handles and stores — especially if you move it between job sites.

Specifications

Design by 3dprtr