Makita DC18RC Charger Wall Mount – Tidy Workshop Fix

If your Makita DC18RC charger is sitting on a shelf eating up bench space — or worse, dangling from its cord on the floor — this wall mount puts an end to that. A dedicated holder gets your charger up off the work surface, keeps the cable from being a trip hazard, and means you always know exactly where it is when a battery needs topping up.

How it solves the problem

The mount is shaped specifically around the DC18RC charger body. It grips the unit securely without blocking the battery slot or the cooling vents — so you can charge while it's mounted, not just store it there. Two screw points let you fix it to any flat vertical surface: a workshop wall, a van side panel, a garage cabinet, or a job site storage unit.

• Holds your DC18RC charger off the bench and off the floor
• Charging slot stays fully accessible while mounted
• Keeps cables managed and out of the way
• Low-profile fit — doesn't add unnecessary bulk
• Works on wood, plasterboard, metal sheeting, and van ply lining

Where to mount it

Most people put this directly above their main charging station — screwed into a shelf upright or stud wall. In a van, it works well on the bulkhead or side wall near a 240V socket. If you run a multi-bay charge point, you can stack several of these vertically to keep your whole Makita setup in one clean column.

The everyday wins

It sounds like a small thing until you're mid-job hunting for the charger under a pile of extension leads. Having it mounted means it's always in the same spot, the cord is never in the way, and your workspace stays cleaner with no effort. Mount it once, forget about it — the charger just lives there now.

Arrives ready to mount. Just add two screws.

Specifications

Design by andywaudby87